2011

If LAYOUTREGENCTL is set to 1 or 2 and performance seems slow in general
or when you switch between tabs for which the display list is saved, consider
changing to a setting of 0 or 1 to find the optimal balance for your work
environment.
Regardless of the LAYOUTREGENCTL setting, if you redefine a block or undo
a tab switch, the drawing is regenerated the first time you switch to any tab
that contains saved viewports.
LEGACYCTRLPICK
Quick Reference
See also:
■ Select Objects Individually
■
SUBOBJSELECTIONMODE on page 1502
■ Cycle Through and Filter Subobjects
IntegerType:
RegistrySaved in:
2Initial value:
Specifies the keys for selection cycling and the behavior for Ctrl-click.
Ctrl+click is used to select subobjects (faces, edges, and
vertices) on 3D solids, surfaces, and meshes.
0
Ctrl+click is used to cycle through overlapping objects.
Disallows using Ctrl+click to select subobjects on 3D solids,
surfaces, and meshes.
1
Ctrl+click is used to select subobjects (faces, edges, and
vertices) on 3D solids, surfaces, and meshes when SUB-
2
OBJSELECTIONMODE on page 1502 is set to 0.If SUBOBJSE-
LECTIONMODE is set to 1, 2, 3, or 4, it is not necessary
to hold down the Ctrl key to select subobjects.If you hold
down the Ctrl key when SUBOBJSELECTIONMODE is set
to 1, 2, 3, or 4, the subobject filter is turned off until the
Ctrl key is released.
LEGACYCTRLPICK | 1389