2011

Multiline Text Width
Specifies the maximum length of the lines of text in a multiple-line attribute
before wrapping to the next line. A value of 0.000 means that there is no
restriction on the length of a line of text.
Not available for single-line attributes.
Advanced Options
Contains options to set the behavior and insertion position for the attribute.
Attribute Options
Sets options for attribute values associated with a block when you insert the
block in a drawing.
The default values are stored in the AFLAGS on page 1177 system variable.
Changing the AFLAGS setting affects the default mode for new attribute
definitions and does not affect existing attribute definitions.
Invisible
Specifies that attribute values are not displayed or printed when you insert
the block.
ATTDISP on page 102 overrides Invisible mode.
Constant
Gives attributes a fixed value for block insertions.
Verify
Prompts you to verify that the attribute value is correct when you insert the
block.
Preset
Sets the attribute to its default value when you insert a block containing a
preset attribute.
Lock Position
Locks the location of the attribute within the block reference. When unlocked,
the attribute can be moved relative to the rest of the block using grip editing,
and multiline attributes can be resized.
Multiple Lines
Specifies that the attribute value can contain multiple lines of text. When this
option is selected, you can specify a boundary width for the attribute.
NOTE In a dynamic block, an attribute's position must be locked for it to be
included in an action's selection set.
98 | Chapter 2 A Commands