2011

The integer represents 1/100th of a mm.
DIMPOST
Quick Reference
See also:
■ Control the Display of Dimension Units
StringType:
DrawingSaved in:
NoneInitial value:
Specifies a text prefix or suffix (or both) to the dimension measurement.
For example, to establish a suffix for millimeters, set DIMPOST to mm; a
distance of 19.2 units would be displayed as 19.2 mm.
If tolerances are turned on, the suffix is applied to the tolerances as well as to
the main dimension.
Use <> to indicate placement of the text in relation to the dimension value.
For example, enter <>mm to display a 5.0 millimeter radial dimension as
"5.0mm". If you entered mm <>, the dimension would be displayed as "mm
5.0". Use the <> mechanism for angular dimensions.
DIMRND
Quick Reference
See also:
■ Round Off Dimension Values
RealType:
DrawingSaved in:
0.0000Initial value:
Rounds all dimensioning distances to the specified value.
For instance, if DIMRND is set to 0.25, all distances round to the nearest 0.25
unit. If you set DIMRND to 1.0, all distances round to the nearest integer.
DIMPOST | 1257