2011

Toolbar: Modeling tool set ➤ Solids - Create tool group ➤ Solid Primitive
flyout ➤ Weblight
Menu: Draw ➤ 3D Modeling ➤ Wedge
Summary
The direction of the taper is always in the positive X-axis direction of the UCS.
List of Prompts
The following prompts are displayed.
Specify first corner or [
Center on page 1137]: Specify a point or enter c for center
Specify other corner or [
Cube on page 1138/Length on page 1138]: Specify the other
corner of the wedge or enteran option
If the other corner of the wedge is specified with a Z value that differs from
the first corner, then no height prompt is displayed.
Specify height or [
2Point on page 1138] <default>: Specify the height or enter 2P
for the 2 Point option
Entering a positive value draws the height along the positive Z axis of the
current UCS. Entering a negative value draws the height along the negative
Z axis.
Center
Creates the wedge by using a specified center point.
Cube Creates a wedge with sides of equal length.
WEDGE | 1137