2011

Diameter
Defines the diameter of the torus.
■ Radius on page 1062
■ Diameter on page 1062
TRACE
Quick Reference
See also:
■ Draw Linear Objects
Creates solid lines.
Summary
The endpoints of a trace are on the center line and are always cut square.
TRACE automatically calculates the correct bevels for connection to adjacent
segments. Each segment is drawn after you either specify the next segment
or press Enter. Because of the way bevels are handled, TRACE has no undo
option.
Traces are solid filled when Fill mode is on. When Fill mode is off, only the
outline of a trace is displayed.
List of Prompts
The following prompts are displayed.
Specify trace width <current>: Specify a distance or press Enter
Specify start point: Specify a point (1)
Specify next point: Specify a point (2)
Specify next point: Specify a point (3) or press Enter to end the command
TRACE | 1063