2011

The surface will be dependent on the curves or edges from which it was created
if the
SURFACEASSOCIATIVITY on page 1507 system variable is set to 1.
List of Prompts
The following prompts display:
Select Curves or Surface Edges in the First Direction Select a network
of open curves, open surface edges, or region edges (not the surfaces or regions)
for the U or V direction.
Select Curves or Surface Edges in the Second Direction Select a network
of open curves, open surface edges, or region edges (not the surfaces or regions)
for the U or V direction.
Bulge Magnitude Sets the roundness of the network surface edge where it
meets the originating surface. Valid values are between 0 and 1. The default
is 0.5. This option displays only if a lofting edge belongs to a 3D solid or
surface (not a curve).
1018 | Chapter 19 S Commands