2011

Table Of Contents
the file is already in use by another text style. You can define several styles
that use the same font file.
Match Text Orientation to Layout If you enter yes the current text style
orientation in paper space viewports matches the layout.
Height of Text If you enter a height of 0.0, you are prompted for the text
height each time you enter text using this style. Entering a height greater than
0.0 sets the Text Height (Non annotative), entering a height greater than 0.0
sets the Paper Text Height (Annotative), for this style.
Width Factor Entering a value less than 1.0 condenses the text. Entering a
value greater than 1.0 expands it.
Obliquing Angle Entering a value between -85 and 85 obliques the text.
Vertical Vertical is available only if the selected font supports dual orientation.
?List Text Styles Lists the text styles available in the drawing.
At the Enter Text Style(s) to List prompt, entering the name of a style displays
the name, font file, height, width factor, obliquing angle, and generation of
the style and exits the command. Entering an asterisk (*) or pressing Enter
displays the height, width factor, obliquing angle, and generation (whether
text is drawn backwards, upside-down, vertically, or normally) of each style,
and then exits the command.
SUBTRACT
Quick Reference
See also:
Create Composite Objects
Combines selected 3D solids or 2D regions by subtraction.
Access Methods
Button
1010 | Chapter 19 S Commands