2011

For splines that are not selected, use the CVSHOW on page 239 and CVHIDE
on page 233 commands to display and hide the control vertices and control
frame.
For splines created with control vertices, you can display the control frame
by selecting the spline.
List of Prompts
The following prompts are displayed.
Specify first point or [
Method on page 987/Degree on page 991/Object on page
989]:
Method
Controls whether the spline is created with fit points or with control vertices.
The options available differ depending on the method. See
Options for Splines
with Fit Points
on page 989 or Options for Splines with Control Vertices on
page 991.
Fit Creates a degree 3 (cubic) B-spline by specifying fit points that the spline
must pass through or, when the tolerance value is greater than 0, within the
specified tolerance distance.
Changing the Method updates the
SPLMETHOD on page 1500 system variable.
SPLINE | 987