2011

Two points define the inclined plane used for the auxiliary projection. Both
points must be located in the same viewport.
A rubber-band line perpendicular to the inclined plane helps you select the
center of the new viewport.
Section
Creates a drafting sectional view of solids, complete with cross-hatching. When
you use SOLDRAW on a sectional view created with this option, it creates a
temporary copy of the solids and uses SLICE to perform the operation at the
cutting plane that you define. SOLDRAW then generates a profile of the visible
half of the solids and discards the original copy. Finally SOLDRAW sections
the solids. Solids not crossing the cutting plane are generated as full profiles.
Because drafting standards recommend not drawing hidden lines in sectional
views, SOLVIEW freezes the View Name-HID layer.
SOLVIEW | 979