2011

■ Select faces (taper)
■ Undo
■ Remove
■ All
Select faces (taper) Specifies the faces to be tapered and then sets the slope
of the taper.
■ Base point. Sets the first point for determining the plane.
■ Another point along the axis of tapering. Sets the orientation of the axis
that determines the direction of the taper.
■ Taper angle. Specify an angle between -90 and +90 degrees to set the slope
of the taper from the axis.
Face: Delete
Delete Deletes or removes faces, including fillets and chamfers.
Use this option to remove and later modify filleted and chamfered edges. The
face is not deleted if the change results in a non-valid 3D solid.
SOLIDEDIT | 965