2011

Table Of Contents
Remove
All
Select faces (offset) Specifies the faces you want to offset.
NOTE The size of holes inside a solid object that is offset decreases as the volume
of the solid increases.
Specify the offset distance. Sets a positive value to increase the size of the
solid or a negative value to decrease the size of the solid.
Face: Taper
Taper Tapers faces on a 3D solid at a specified angle. The rotation of the taper
angle is determined by the selection sequence of the base point and second
point along the selected vector.
A positive angle tapers the face in, and a negative angle tapers the face out.
The default angle, 0, extrudes the face perpendicular to its plane. All selected
faces in the selection set are tapered to the same value.
964 | Chapter 19 S Commands