2011

NOTE You can also automatically set wire number placement using the
Drawing Properties tool. Follow these steps.
3 In the Project or Drawing Properties dialog box, click the Wire Numbers
tab.
4 In the Wire Number Placement section, select how you want to place
new wire numbers automatically: above, below, or inline of the wire.
■ Above Wire: Places the wire number above the physical wire.
■ In-Line: Places the wire number in line with the wire. Click Gap Setup
to define the spacing between the wire number and the wire itself.
■ Below Wire: Places the wire number below the physical wire.
5 Click OK.
NOTE Use the Copy Wire Number (In-Line) tool to insert individual wire numbers
inline with the wire rather than above or below the wire in the active drawing.
Apply drawing-specific wire number settings. These settings are maintained
inside the WD_M block in the drawing.
Any drawing
Ribbon: Project tab ➤ Project Tools panel ➤ Manager.
Toolbar: Main Electrical 2
Menu: Projects ➤ Project Manager
Command entry: AEPROJECT
In the Project Manager, right-click the drawing name, and select Properties
➤ Drawing Properties. Select the Wire Numbers tab.
Active drawing
Ribbon: Schematic tab ➤ Other Tools panel ➤ Drawing Properties
drop-down ➤ Drawing Properties.
Set wire number placement | 979