2011

1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify
Wires drop-down ➤ Stretch Wire.
2 Select the end of the wire to stretch.
Bend wires at right angles
Bend wires at right angles
Bends a wire in a right angle and makes three right angle turns to avoid or
add geometry.
You can modify the wire defined at a right angle. You can replace the right
angle bend while maintaining the original wire connections to the
components.
NOTE This tool terminates if the bend attempts to connect two different wire
networks or if the bend bypasses more than a single right-angle turn.
1 Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify Wires
drop-down ➤ Bend Wire.
2 Select one of the two wires that make up a right-angle turn.
3 Select the opposing wire that makes up the right-angle turn.
The additional wire segments are added based on the right-angle direction.
Bend wires at right angles | 921