2011

Table Of Contents
Inserts vertical or horizontal bus wiring. Bus spacing defaults to the default
ladder rung spacing for horizontal bus. For a vertical bus, the spacing is the
default value defined in the Ladder Defaults section in the Drawing Properties
Drawing Format dialog box.
NOTE You can use the Scoot command to adjust bus spacing after insertion.
Specifies the horizontal spacing between the wires.Horizontal
Specifies the vertical spacing between the wires.Vertical
Interconnect components
Interconnect components
Inserts wires between aligned connection points on a pair of selected
components.
1 Click Schematic tab Insert Wires/Wire Numbers panel Insert Wires
drop-down Interconnect Components.
2 Select the first component.
3 Select the second component.
NOTE Wires are added only if the wire connection points are aligned.
918 | Chapter 12 Wire/Wire Number Tools