2011

Table Of Contents
Insert multiple wires
Insert multiple wires
1 Click Schematic tab Insert Wires/Wire Numbers panel Multiple
Bus.
2 Set the horizontal and vertical spacing for the wires.
3 Specify where to start the wires.
4 Set the number of wires to 3, and click OK.
During wire insertion, the current wire type displays at the command
prompt. The current wire type indicates the layer name in which the new
wires are drawn. You can override it by typing "T" and selecting a new
wire type from the Set/Edit Wire Type dialog box. The new wire type
becomes the current wire type and the command continues with the wire
insertion.
5 If starting at a component or bus, select the component. Drag the cursor
slowly to the right as the second and third phases latch on to their
appropriate vertical wires. You can see the three wires stretch straight
across the screen.
916 | Chapter 12 Wire/Wire Number Tools