2011

Table Of Contents
Change wire types
Change wire types
You can change the wire type using the Change/Convert Wire Type tool or
by typing a "T" at the command prompt during wire insertion commands.
1 Click Schematic tab Edit Wires/Wire Numbers panel Modify Wire
Type drop-down Change/Convert Wire Type.
Optionally, you can right-click on an existing wire and select
Change/Convert Wire Type.
2 In the Change/Convert Wire Type dialog box, select a wire type record
in the wire type list, or click Pick to select a wire type record from the
drawing.
If you right-clicked on a wire and selected Change/Convert Wire Type,
the wire type corresponding to the selected wire layer is highlighted in
the list.
3 Make any selections in the dialog box.
If Change all wires in the wire network is selected, all wires in the wire
network are changed to the new wire type. If unselected, only the selected
wire is changed.
If Convert Lines to Wires is selected, the selected lines are changed to the
new wire type. If unselected, the lines are ignored.
4 Click OK.
5 Select the wires or lines in the drawing to change and press Enter.
Override wire type at command prompt
During wire insertion, the current wire type displays at the command prompt.
You can override the wire type by typing in the hot key "T" and selecting a
new wire type from the Set Wire Type dialog box. The new wire type becomes
the current wire type and the command continues with the wire insertion.
Use the following commands:
Click Schematic tab Insert Wires/Wire Numbers panel Insert Wires
drop-down Wire.
Change wire types | 907