2011

Add wire jumpers by picking
1 Click Schematic tab ➤ Edit Components panel ➤ Edit Components
drop-down ➤ Internal Jumper.
2 Select the component.
3 Click Pick. The dialog closes. You can select as many terminals as you
want.
Try to select as near the terminal as you can since AutoCAD Electrical
finds the closest connection terminal to your selected point.
4 After you select the terminals, press Enter and the dialog displays.
Notice that the selected terminals are highlighted in the list.
5 Click Add to finish defining the jumper.
Change an existing jumper assignment
1 Click Schematic tab ➤ Edit Components panel ➤ Edit Components
drop-down ➤ Internal Jumper.
2 Select the component.
3 Select the jumper from the list on the right.
Once selected, the terminals that are part of this jumper assignment are
highlighted on the terminal list.
4 Reselect the terminals to be jumpered, using the Shift and CTRL keys as
needed.
5 Click Update once the appropriate terminals are highlighted.
Wire jumpers
You can add, change, or delete internal jumpers on a selected component.
When wire numbers are inserted, these internal jumpers are read and wire
numbers are assigned accordingly.
If you select to jumper two pins on a component together, an alert displays
indicating that internal jumpering will cause a conflict with the existing wire
number assignments. If you click Continue, an internal jumper inserts between
856 | Chapter 10 Component Tools