2011

Table Of Contents
Insert P&ID Component
Stand-alone source or destination cross-reference
symbol
You use stand-alone cross-reference symbols just as you would wire
source/destination arrow symbols but without the wires. Insert a source
reference symbol and then tie one or more destination reference symbols to
it. They can be on the same drawing or scattered across the project drawing
set.
Ribbon: Schematic tab Insert Components panel Dashed Link Line
drop-down Insert Stand-Alone Cross-Referencing.
Toolbar: Cross-Reference
Menu: Components Cross-Reference Insert Stand-Alone
Cross-Reference
Command entry: AESAXREF
Select the cross-reference component to insert and place it on the drawing.
Specifies the unique name for the source/destination pair. This links
each source cross-reference symbol to its destination cross-reference
symbols.
Code
(for Hexagon symbols only) Displays the sheet (Drawing Property)
value for the drawing the matching symbol.
Sheet
Displays the line reference value for the matching symbol.Reference
(optional) Specifies the description for the symbol.Description
Provides a list of source or destination symbols inserted this AutoCAD
session.
Recent
Displays drawing-wide pick lists of all source/destination codes used
so far.
Drawing
Use stand-alone cross-reference symbols | 843