2011

Table Of Contents
7 Click OK.
If you selected to use the Table Format style, the table location is based
on the cross reference attribute position. You can move the table to any
location on the drawing and the table remains in the new position for
that symbol.
Cross-reference component override
You can define components to have different cross-referencing styles. The
settings specified using this tool override the drawing properties. Component
overrides are copied when the component is copied; similarly they are applied
to multiple inserts of the same component.
Ribbon: Schematic tab Edit Components panel Modify Component
Cross-Reference drop-down Copy/Add Component Override.
Toolbar: Cross-Reference
Menu: Components Cross-Reference Copy/Add Component
Override
Command entry: AECOPYOVERRIDE
NOTE You can also access this when you use Insert Component on page 742.
Select the component type to insert and specify the insertion point on the drawing.
In the Insert/Edit Component dialog box, Cross-Reference section, select
Component override and click Setup.
Select the component with settings to copy or override.
Defines the cross-reference annotation format. One
replaceable parameter, %N, must always be part of
Cross-Reference Format
the cross-reference format string. A typical format
string might be just the %N parameter. Use the up-
per section for on-drawing references and the bottom
section for off-drawing references. You can use the
same format for both.
Overview of cross-reference settings | 817