2011

Table Of Contents
4 Select a point above the first wire that you want to process.
5 Select a point below the final wire for processing, and then right-click to
end the command.
6 With each possible insertion point (that is, fence crossing point with a
wire) a dialog box displays, prompting you to decide whether to keep the
insertion, keep all of the insertions, or skip to the next one.
If you keep the insertion point, the regular Insert/Edit dialog box is
displayed, where you finish annotating the component.
7 Click OK to complete the operation.
Copy a component to fence crossing points
Inserts copies of a selected component at each point where a defined fence
crosses a wire.
With each possible insertion point, specify whether to keep the insertion,
keep all the insertions, or skip to the next one.
1 Click Schematic tab Insert Components panel Multiple Insert
drop-down Multiple Insert (Pick Master).
2 Select the component to copy.
3 Select a point above the first wire that you want to process.
4 Select a point below the final wire for processing, and then right-click to
end the command.
Insert a copy of a component | 775