2011

Table Of Contents
Ribbon: Schematic tab Edit Components panel Edit Components
drop-down Edit.
Toolbar: Main Electrical
Menu: Components Edit Component
Command entry: AEEDITCOMPONENT
Select the component to edit. In the Insert/Edit Component dialog box, Pins
section, click List.
The three lists display all available pins to assign to the compon-
ent. The number in parenthesis () indicates the single or pair of
Pin List
pins for the component. Pins can be Unused NO Pairs, Unused
Form-C contacts, and undefined.
Displays the sheet number and potential reference line number
where the connector definition is located in the project.
Sheet, Reference
Displays the contact type (for example, "NO" or "NC"). It is the
value carried by the CONTACT attribute of the component. If no
attribute is present or this attribute is blank, then this field is blank.
Type
Displays the pin numbers already in use in the project.Pins
Displays the wire numbers carried on wires attached to each of
the pins above. If no wire connection to the pin, or if the wire
does not carry a wire number assignment, then this field is blank.
Wire Numbers
Insert or edit child components
Insert or edit child component
Insert Component
Ribbon: Schematic tab Insert Components panel Insert
Components drop-down Icon Menu.
764 | Chapter 10 Component Tools