2011

DescriptionCommand
Bends a wire in a right angle and makes 3
right angle turns to avoid or add geometry.
Bend Wire
AEBENDWIRE
When a wire is defined at a right angle you
can modify the wire and create a new right
angle bend while maintaining the original wire
connections to the components.
NOTE This tool terminates if the bend at-
tempts to connect two different wire networks
or if the bend bypasses more than a single
right angle turn.
Highlights all wires and displays wire number
to wire segment relationships.
Show Wires
AESHOWWIRE
Helps troubleshoot problems with unconnec-
ted or shorted wires and invalid wire crossing
Check/Trace Wire
AETRACEWIRE
gap pointers by single stepping through and
highlighting each connected wire of the selec-
ted wire network.
Flips the wire number across its associated
wire.
Flip Wire Number
AEFLIPWIRENO
Switches the wire number between above or
below and in-line. If the selected wire number
Toggle Wire Number In-
line
is in-line, it toggles to above or below based
on the default Wire Number Placement setting
AETOGGLEWIRENO
in the Drawing Properties dialog box. If it
starts as above or below, the selected wire
number toggles to in-line.
NOTE If there isn't room for a wire number
to become an in-line wire number, it remains
an above or below line wire number.
Schematic tab | 55