2011

Temporarily closes the dialog box so that you can select
an existing motor symbol and reuse the values from
the motor.
Displays or sets the full load amps (FLA) value. The FLA
value is multiplied by the FLA Multiplier value to cal-
culate the Maximum load value.
FLA
Sets the multiplier factor. The FLA value is multiplied
by this value to calculate the Maximum load value.
FLA multiplier
Displays the calculated maximum load based on the
product of FLA and FLA multiplier.
Maximum load
NOTE The initial default values used for Voltage and the FLA multiplier are
controlled from the active OPT table in the electrical standards database file.
Select Load
Browse the load table, named FEED in the electrical standards database file,
ace_electrical_standards.mdb, and select the appropriate load and annotation
values. You can also modify the lookup table from this dialog box.
Ribbon: Schematic tab ➤ Insert Components panel ➤ Circuit Builder
drop-down ➤ Circuit Builder.
Toolbar: Main Electrical
Menu: Components ➤ Circuit Builder
Command entry: AECIRCBUILDER
On the Select Circuit dialog box, select a power feed circuit, click Configure,
and then select the Load Setup Browse button.
Filter the listing based on load type. Select <All> from the list to
turn off filtering for this field.
Type
Filter the listing based on voltage. Select <All> from the list to
turn off filtering for this field.
Voltage (V)
Use Circuit Builder | 711