2011

Table Of Contents
Displays the Wire Size Lookup dialog box. Use this dialog to select
a wire size based on load and various other parameters.
Wire Setup
Select Motor
Browse the motor lookup table in the electrical standards database,
ace_electrical_standards.mdb, and select the appropriate motor and annotation
values. You can also modify the motor lookup table from this dialog box.
Ribbon: Schematic tab Insert Components panel Circuit Builder
drop-down Circuit Builder.
Toolbar: Main Electrical
Menu: Components Circuit Builder
Command entry: AECIRCBUILDER
On the Select Circuit dialog box, select a circuit, click Configure, and then
select the Motor Setup Browse button.
Filter the listing based on motor type. Select <All> from the list
to turn off filtering for this field.
Type
Filter the listing based on motor voltage. Select <All> from the
list to turn off filtering for this field.
Voltage (V)
Filter the listing based on motor frequency. Select <All> from the
list to turn off filtering for this field.
Frequency (HZ)
Select a motor to pass the values back to the Circuit Configuration
dialog box.
Selection grid
Specifies whether you can edit or select the values.
Values you edit are written back to the electrical
standards database file.
Edit or add records
710 | Chapter 9 Circuits