2011

DescriptionCommand
Moves the wire number out of the hide layer
so that the number is visible on the screen.
Unhide Wire Numbers
AESHOWWIRENO
Removes a wire segment and dots as required.
You can select a single wire or draw a fence
through multiple wires to trim.
Trim Wire
AETRIM
Deletes selected wire numbers.Delete Wire Numbers
AEERASEWIRENUM
NOTE If you erase a wire number and select
right on an extra wire number copy, AutoCAD
Electrical erases just that copy but leaves the
network’s main wire number and any other
copies in place.
Finds the nearest line reference location and
places a ladder rung at that reference position
Add Rung
AERUNG
(both bus wires must be visible on the screen
for this to work. If the new rung encounters a
schematic device floating in space, it tries to
break the wire across the device.
Adjusts the line reference numbering along
the side of the ladders; however it doesn't
change existing ladder rung spacing.
Revise Ladder
AEREVISELADDER
Renumbers the ladder for the selected draw-
ings from the active project.
Renumber Ladder Refer-
ence
AERENUMBERLADDER
Creates and edits wire types. Use the grid
control to sort and select the wire types for
easy modification.
Create/Edit Wire Type
AEWIRETYPE
Changes between wire types and converts
lines to wires. Use the grid control to sort and
select the wire types for easy modification.
Change/Convert Wire
Type
AECONVERTWIRETYPE
Schematic tab | 53