2011

5 (Optional) Select to apply some specific annotation:
■ Presets on page 2072 - defined in the ANNO_CODE sheet of the Circuit
Builder spreadsheet file that map to the selected circuit.
■
Reference an existing circuit on page 723 - reference values from an
existing circuit selected from a list of circuits extracted from the active
project. The state of the Retag new components check box controls
the retagging of the components within the new circuit. Values can
include catalog assignment, component descriptions, annotation
values, and more.
NOTE This option is not available if the circuit is selected from the History
list.
6 Select Insert.
A circuit inserted from the Circuits list contains all default circuit elements
as defined in the circuit template and circuit builder spreadsheet. See Set
circuit element defaults
on page 2075 to change default circuit setup.
7 Select an insertion point location on the drawing.
Configure a one-line circuit
Configures and builds a one-line circuit based on your selection from a list of
available circuits and circuit elements.
NOTE Add the one-line library search path on page 204 to the project so Circuit
Builder can find the one-line circuit templates. By default, the one-line library is
installed in a 1- folder under the schematic library folder.
1 Click Schematic tab ➤ Insert Components panel ➤ Circuit Builder
drop-down ➤ Circuit Builder.
2 Select the circuit from the Circuits list. For example:
Circuits: One-line Motor Circuit, Vertical - FVNR - non reversing
NOTE You can also select History to display the list of previously inserted
circuits.
700 | Chapter 9 Circuits