2011

2 Select the circuit from the Circuits list. For example:
Circuits: 3ph Power Feed, Horizontal - Dual feed.
NOTE You can also select History to display the list of previously inserted
circuits.
3 (Optional) Enter a Circuit Scale. This value sets an insertion scale value
for the circuit template.
4 (Optional) Enter a Component Scale. This value sets an insertion scale
value for the individual components inserted while building the circuit.
5 (Optional) Enter a Horizontal Rung Spacing.
6 (Optional) Enter a Vertical Rung Spacing.
7 (Optional) Select to apply some specific annotation:
■
Presets on page 2072 - defined in the ANNO_CODE sheet of the Circuit
Builder spreadsheet file that map to the selected circuit.
■
Reference an existing circuit on page 723 - reference values from an
existing circuit selected from a list of circuits extracted from the active
project. The Retag new components check box controls the retagging
of the components. Values can include catalog assignment, component
descriptions, annotation values, and more.
NOTE This option is not available if the circuit is selected from the History
list.
8 Select Configure.
9 Select an insertion point location on the drawing. The template drawing
for the dual power feed is inserted at the specified location. The template
drawing contains marker blocks, with instructions for building the circuit,
and the circuit wiring.
The dialog box has three sections, Circuit Elements, Select, and Setup &
Annotations. The options differ depending on the circuit selected.
NOTE The circuit elements with a “(2)” prefix make up the second circuit.
10 Select a circuit element, for example:
Circuit Elements: Load
Use Circuit Builder | 697