2011

■ Reference an existing circuit on page 723 - reference values from an
existing circuit selected from a list of circuits extracted from the active
project. The state of the Retag new components check box controls
the retagging of the components within the new circuit. Values can
include catalog assignment, component descriptions, annotation
values, and more.
NOTE This option is not available if the circuit is selected from the History
list.
8 Select Insert.
9 Select an insertion point location on the drawing.
Configure a power feed circuit
1 Click Schematic tab ➤ Insert Components panel ➤ Circuit Builder
drop-down ➤ Circuit Builder.
2 Select the circuit from the Circuits list. For example:
Circuits: 3ph Power Feed, Horizontal - Single feed.
NOTE You can also select History to display the list of previously inserted
circuits.
3 (Optional) Enter a Circuit Scale. This value sets an insertion scale value
for the circuit template.
4 (Optional) Enter a Component Scale. This value sets an insertion scale
value for the individual components inserted while building the circuit.
5 (Optional) Enter a Horizontal Rung Spacing.
6 (Optional) Enter a Vertical Rung Spacing.
7 (Optional) Select to apply some specific annotation:
■ Presets on page 2072 - defined in the ANNO_CODE sheet of the Circuit
Builder spreadsheet file that map to the selected circuit.
■
Reference an existing circuit on page 723 - reference values from an
existing circuit selected from a list of circuits extracted from the active
project. The state of the Retag new components check box controls
694 | Chapter 9 Circuits