2011

■ The selection information for the circuit is applied to the main
component of the circuit, for example the motor or load symbol.
■ The remaining marker blocks are removed from the circuit template
for any circuit elements not inserted.
NOTE The Circuit Elements list is built dynamically based on the template for the
selected circuit. As the circuit elements are inserted, if the element contains a
nested circuit, the circuit element becomes expandable so you can configure the
nested circuit elements.
Insert a power feed circuit
1 Click Schematic tab ➤ Insert Components panel ➤ Circuit Builder
drop-down ➤ Circuit Builder.
2 Select the power feed circuit. For example:
Circuits: 3ph Power Feed, Horizontal - Single feed
NOTE You can also select History to display the list of previously inserted
circuits.
A circuit inserted from the Circuits list contains all default circuit elements
as defined in the circuit template and circuit builder spreadsheet. See
Customize Circuit Builder on page 2005 to change the default circuit setup.
A circuit inserted from the History list contains all circuit elements and
values of the previously inserted circuit.
3 (Optional) Enter a Circuit Scale. This value sets an insertion scale value
for the circuit template.
4 (Optional) Enter a Component Scale. This value sets an insertion scale
value for the individual components inserted while building the circuit.
5 (Optional) Enter a Horizontal Rung Spacing.
6 (Optional) Enter a Vertical Rung Spacing.
7 (Optional) Select to apply some specific annotation:
■
Presets on page 2072 - defined in the ANNO_CODE sheet of the Circuit
Builder spreadsheet file that map to the selected circuit.
Use Circuit Builder | 693