2011

DescriptionCommand
Inserts a gap/loop at the point of two crossing
lines. Gaps are automatically inserted when a
new wire crosses another.
Insert Wire Gap
AEWIREGAP
Inserts vertical or horizontal bus wiring. Bus
spacing defaults to the default ladder rung
Multiple Wire Bus
AEMULTIBUS
spacing for horizontal bus. Multiple bus wiring
automatically breaks and reconnects to any
underlying components that it finds in its
path. If it crosses any existing wiring, wire-
crossing gaps automatically insert (if the
drawing is so configured).
Inserts or updates wire numbers associated
with wire line entities.
Insert Wire Numbers
AEWIRENO
Inserts special wire numbering generally asso-
ciated with 3-phase bus and motor circuits.
3 Phase Wire Numbers
AE3PHASEWIRENO
Inserts wire numbers based on the I/O address
that each PLC connected wire touches. Wire
PLC I/O Wire Numbers
AEPLCWIRENO
numbers go in as FIXED which means that
they will not change if a wire number retag is
run later on.
Copies wire number from a source-arrowed
wire network to any/all associated destination-
arrowed wire network.
Source Signal Arrow
AESOURCE
Retrieves the wire number for a destination-
arrowed wire network from its associated
source-arrowed wire network.
NOTE A Destination signal arrow cannot be
tied to a wire network that carries a pre-as-
signed fixed wire number.
Destination Signal Arrow
AEDESTINATION
Schematic tab | 49