2011

■ Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Multiple
Bus.
■ Click Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify Ladder
drop-down ➤ Add Rung.
■ Click Schematic tab ➤ Insert Wires/Wire Numbers panel ➤ Insert Ladder
drop-down ➤ Insert Ladder.
NOTE If you select Another Bus (Multi-Wire) in the Multiple Wire Bus dialog box,
the wires are drawn on the same wire layer as the existing wire bus. You cannot
type "T" to change the wire type during wire insertion.
Change/convert wire type
Convert lines to wires, or change wires from one wire type to another.
TIP Use the Create/Edit Wire Type tool to create and edit wire types. You can also
type "T" at the command prompt during wire insertion to use the Set Wire Type
tool.
Ribbon: Schematic tab ➤ Edit Wires/Wire Numbers panel ➤ Modify
Wire Type drop-down ➤ Change/Convert Wire Type.
Toolbar: Wires
Menu: Wires ➤ Change/Convert Wire Type
Command entry: AECONVERTWIRETYPE
You can also right-click on an existing wire and select Change/Convert Wire
Type. Use the grid control to sort and select the wire types for modification.
Wire type grid
Displays the wire types used in the active drawing. The wire layer name and
the wire properties like color, size, whether the wire layer is processed for wire
numbers, and user-defined properties are listed in the grid. An 'x' in the Used
column indicates that the layer name is currently used in the drawing. A blank
value in this column indicates that the layer name exists in the drawing but
it is not currently being used.
Change wire types | 275