2011

Table Of Contents
X-Y referencing format: 0 = V-H, 1 = H-VHOIRZ_FIRST
X-Y delimiter characterXY_DELIM
Styles
PLC module style code (default = 1)PLC_STYLE
default signal arrow style numberARROW_STYLE
Miscellaneous
list of 3 in line wire number/label gap settings (see WNUM_FLAGS
bit 1 for toggle mode); value saved to GBL_wd_inline_gapas a
list. nil or "(num1 num2 num3)"
WNUM_GAP
miscellaneous flagsMISC_FLAGS
0 = gap
1 = loop
2 = no gap
1's bit = mm full-size
2's bit = ignore non lay0 lay vector
4's bit = use plc wire numbers
8's bit = insert new ladders without references
16's bit = search for PLC address on component insert
32+64 bit =
10 = none
01 = angle 1
11 = angle 2
00 = dot
Change the WD_M block
You can change the WD_M block so that your settings are always the default.
1 Open an existing AutoCAD Electrical drawing and set the properties and
layer names.
Overview of the WD_M block | 253