2011

Equivalent of "%L%1" (IEC comp tag)%4
Equivalent of "%L%1:%P" (tag:term)%5
Equivalent of "%L%1:%P:%D" (tag:term:termdesc)%6
Equivalent of "%I%I%1" (INST prefix+IEC comp tag)%7
Equivalent of "%I%L%1:%P" (tag:term)%8
Equivalent of "%I%L%1:%P:%D" (tag:term:termdesc)%9
The part after the colon(:) is suppressed if the value is blank in %2 - %9
parameters (for example, %2=comp tag:term). The ":term" part is suppressed
if blank.
Save settings to the project file
Save settings to the project file
The changes you make to the configuration of the current drawing are saved
on the invisible WD_M block of the drawing. You can save a copy of these
settings to the project file. It makes the settings available as defaults for new
drawings that you might add later to the project. Alternately, you can retrieve
selected settings previously saved in the project file and assign them to the
current drawing.
1 Click Schematic tab ➤ Other Tools panel ➤ Drawing Properties
drop-down ➤ Settings Compare.
AutoCAD Electrical reads both the settings on the WD_M block of the
current drawing and a copy of the settings maintained in the current
project's .wdp file. Any differences are displayed in a three-column dialog
box.
2 Highlight the settings you want to copy over from the drawing to the
project or vice versa or click Select All to change all the settings quickly.
3 Click Match Project to make the settings of the drawing match the project
defaults or click Match Drawing to make the settings of the project match
the settings of the current drawing.
Save settings to the project file | 239