2011

off (making sure that duplicate wire numbers are not as-
signed).
The default is "1." Setting it to "2" with a starting sequential
of "1" would yield wire numbers 1, 3, 5, 7, 9, 11, and so
on.
Increment
Sets the wire number tag suffix. This list is used to create
unique reference-based wire number tags for multiple wire
Line Reference
networks beginning at the same reference location (such
as wire network beginning at a location per line reference
number, X-Y grid reference, or X-Zone reference).
Displays a suffix list. List suffix characters for wire numbers
beginning on the same line reference or in the same zone
Suffix Setup
(to keep wire numbers unique). Select one of the four
predefined suffix lists or enter your own custom suffix list.
New Wire Number Placement
NOTE The Insert Wire Number tool does not take the current wire number setting
(in-line, above or below) into account when updating existing wire numbers. This
setting is used only when inserting new wire numbers. Use the Toggle Wire Number
In-Line tool for flipping existing wire numbers among the three modes.
Places the wire number above the physical wire.Above Wire
Places the wire number inline with the wire.In-Line
Defines spacing between the inline wire number and the wire it-
self.
Gap Setup
Places the wire number below the physical wire.Below Wire
Specifies to insert the wire number tags the specified offset dis-
tance.
Offset
Specifies to insert the wire number tags in the center of each wire
segment.
Centered
Specifies a fixed, user-defined offset distance from the left or top
of the first wire segment found on the wire network.
Offset Distance
Overview of project and drawing properties | 227