2011

Searches for a connected PLC I/O module's I/O point.
If found, the I/O address value is substituted for the
"%N" part of the default component tag.
Search for PLC I/O address on insert
NOTE This setting is saved in the MISC_FLAGS attrib-
ute on the WD_M block of the drawing.
Enter the beginning sequential number for the
drawing. Sequential tags can continue uninterrupted
Sequential
from one drawing to the next if you assign the same
beginning sequential number to every drawing in
your project. As you insert components on any
drawing of the project set, AutoCAD Electrical starts
with the value you set and works its way up until it
finds the next unused sequential number tag for the
target component family.
NOTE If you finish a drawing and move to the next,
but then later come back to the first drawing to add
another component and sequential tag, a gap ap-
pears in the numbering sequence for that drawing.
Use the AutoCAD Electrical Project-wide Update/Re-
tag tool to retag the whole drawing set.
Set up the unique format tag suffix list. Use this list
to create unique reference-based tags when multiple
Line Reference
components of the same family are located at the
same reference location (for example, three push
buttons on the same line reference "101" could be
labeled PB101, PB101A, and PB101B -- AutoCAD
Electrical does this using a suffix list of " ", "A", "B",
and so on).
NOTE The component tag suffix is automatically
added to the end of the tag, but you can force
AutoCAD Electrical to insert the suffix character
somewhere within the tag format. Use the Suffix
position parameter, %X, in the component tag
format (for example, %N%X - %F).
Displays the suffix list. The individual items in the
suffix list are given in the row of edit boxes across
Suffix Setup
the top of the dialog box. List suffix characters for
duplicate family components on the same line refer-
224 | Chapter 4 Drawing and Project Properties