2011

Table Of Contents
Layers
Defines and manages wire and component layers.
NOTE No matter which layer is current, wires always go to a wire layer and
components to component layers.
Drawing properties: drawing settings tab
Sets default values for a drawing.
Any drawing
Ribbon: Project tab Project Tools panel Manager.
Toolbar: Main Electrical 2
Menu: Projects Project Manager
Command entry: AEPROJECT
In the Project Manager, right-click the drawing name, and select Properties
Drawing Properties. Select the Drawing Settings tab.
Active drawing
Ribbon: Schematic tab Other Tools panel Drawing Properties
drop-down Drawing Properties.
Toolbar: Main Electrical 2
Menu: Projects Drawing Properties
Command entry: AEPROPERTIES
Select the Drawing Settings tab.
Sets the values you enter for drawing description, project, installation, location,
sheet, and drawing code. Sets the format for component tags, wire numbers,
cross-references, PLC modules, signal arrows, ladders, and layers. Overrides
the project properties set in the project Properties dialog box.
220 | Chapter 4 Drawing and Project Properties