2011

Format Referencing
Specifies the default referencing system. There are three modes:
All referencing is tied to an X-Y grid system of numbers and letters
along the left-hand side and top of the drawing. Set the vertical
X-Y Grid
and horizontal index numbers and letters of your drawing, spa-
cing, and origin in the X-Y grid setup dialog box.
TIP Use negative spacing values for Horizontal or Vertical to
change the origin of the X-Y grid system to be other than the
upper left-hand corner of the drawing.
Like X-Y Grid, but there is not a Y-axis. Set the horizontal labels,
spacing, and origin on the X Zones setup dialog box.
X Zones
TIP Use a negative zone spacing value if you want the zone ref-
erence origin to be at the right side of the drawing.
Each ladder column has a column of assigned reference numbers.Reference Numbers
Specifies how to display reference numbers -number only, num-
bers in a hexagon, the sheet and number values, and so on.
Setup
Scale
Sets the scale factor used when inserting new com-
ponents or wire numbers on the drawing. To insert
Feature Scale Multiplier
everything 25% bigger than normal, change the edit
box value from 1.00 to 1.25. This change does not
affect components and wire numbers that are already
present on the drawing.
Select inch if your drawing is to use library symbols
from the JIC1/JIC125 libraries or mm full size for the
inch/inch scaled to mm/mm full size
metric scaled symbol libraries. It adjusts the wire
connection trap distance that determines whether
closely spaced wire ends connector not.
Tag/Wire Number Order
Sets the default wire numbering and component tag sort order for the drawing.
Your selection overrides the project settings for sort order unless you select
No override.
Overview of project and drawing properties | 219