2011

Table Of Contents
6 Highlight all the drawings in Project Manager you wish to apply the
project settings to.
7 Right-click and select Properties Apply Project Defaults.
NOTE When the project settings are applied to a drawing, all settings are applied,
not specific ones.
Drawing settings - change a single drawing
Component tagging options can be changed on a per-drawing basis.
1 Click Project tab Project Tools panel Manager.
2 Highlight the drawing in Project Manager that you wish to change.
3 Right-click and select Properties Drawing Properties.
4 Select the Components tab.
5 In the Component TAG Options section, check the Combined
Installation/Location tag mode option for IEC tagging, uncheck it for JIC
tagging.
If using IEC tagging, set any of the other tagging options.
6 Click OK.
NOTE You can change the component tagging options on the active drawing by
selecting Drawing Properties.
See also:
Configure for IEC standard on page 2119
Use Autodesk Vault with AutoCAD Electrical
Autodesk Vault allows you to keep a history of your design changes. You can
review how your designs have progressed and rollback to a previous version
if necessary. Vault also acts as a central shared secured repository of drawings
Use Autodesk Vault with AutoCAD Electrical | 2127