2011

5 In the Attribute template section, choose Type: (CB) Circuit breakers.
6 In the Select from drawing section, click Select objects and select the
graphics.
7 Select OK.
Add attributes
In this part of the exercise, you insert some AutoCAD Electrical attributes from
the Symbol Builder Attribute Editor. You are not limited to these attributes,
and you can include your own user-defined attributes on the AutoCAD
Electrical block files.
The TAG1 and WDTYPE attributes are the only required attributes for a one-line
parent symbol. The other attributes in the Required section are expected on
a one-line parent symbol, however the symbol is recognized as a one-line
parent symbol without them.
The
WDTYPE on page 325 attribute value must have a value of “1-” for a
one-line symbol or “1-1” for a one-line
bus-tap on page 659 symbol.
1 If the Symbol Builder Attribute Editor is not visible,
Click Symbol Builder tab ➤ Edit panel ➤ Palette Visibility Toggle.
2 Select the TAG1 attribute.
3
Select the Properties tool to launch the Insert/Edit Attributes dialog
box.
4 Change the height to 0.125 and Justify to Center.
The value is predefined as “CB” since the Circuit breaker template was
selected. It is the default code used as the %F value of the tag format (such
as “CR” , “PB”, “LT”)
5 Select OK.
6
Click the Insert Attribute tool.
7 Select an insertion point for the attribute.
Build your own symbols | 2095