2011

action for this combination of selections. The sum is matched to a value
in the UI_SEL field. Once this match is made, the COMMAND_LIST value,
ANNOTATE_LIST value, and so on, are used to insert and annotate the
selections.
5 Edit the API call in the COMMAND_LIST column for this component.
For example, the last argument of this Insert Multi-pole Component API
call is used to predefine MISC1 coded values with nil when nothing extra
is defined.
Before and after are shown:
Before: (c:ace_cb_multipole #xyz nil "HDS11F" 3 #scl 4 nil)
After: (c:ace_cb_multipole #xyz nil "HDS11F" 3 #scl 4
“_TAGFMT=DISC-%N”)
NOTE See the API documentation for more information.
6 Save the spreadsheet.
Override the default wire number format
There are two ways to override the drawing wire number format for a wire
number.
■ On the marker block positioned over the wire in the circuit template
drawing.
■ In the Circuit Builder spreadsheet circuit codes sheet.
NOTE The attribute value defined on the marker block overrides any value defined
in the spreadsheet.
Marker block method
1 Open the circuit template drawing that contains the marker block for
the wire number.
2 Find the correct marker block for the wire number.
3 Edit its MISC1 attribute value using the format “_TAGFMT={format}”, for
example, “_TAGFMT=%N-T1”.
2068 | Chapter 24 Advanced Productivity