2011

The elements in the first sublist of the "#data" list are held in memory in the
following order. The values related to the motor are held in the first eight
elements. See the API documentation for a complete list of elements.
0 Motor Type
1 Power
2 Units
3 Voltage
4 Phase
5 Hertz (Hz)
6 Speed (RPM)
7 Full Load Amps (FLA)
NOTE Circuit Builder numbers this indexed list starting at 0 rather than 1.
There are two ways to map these values to the attributes on a component.
■ On the marker block for the motor, fuse, or circuit breaker symbol in the
circuit template drawing.
■ In the Circuit Builder spreadsheet circuit codes sheet.
NOTE The attribute value defined on the marker block overrides any value defined
in the spreadsheet.
Marker block method
1 Open the circuit template drawing that contains the marker block for
the motor, fuse, or circuit breaker symbol.
2 Find the correct marker block for the symbol.
3 Edit its MISC1 attribute value using the format “{attribute name}=@#@”.
Replace the “#” with the appropriate index digit to map the correct
element. For example, to map the horsepower to the RATING2 attribute,
enter "RATING2=HP: @1@". To also map the full load amp value to the
RATING4 attribute, enter "RATING2=HP: @1@;RATING4=Full load: @7@
amps". Remember, the indexed list of values is zero based.
2064 | Chapter 24 Advanced Productivity