2011

3 Edit its MISC1 attribute value using the format “_D={digit}”, where 1=build
left to right, 2=build up, 4=build right to left, and 8=build down.
For example, if the template has a vertical 3-phase bus and the
disconnection means that marker block is located over the right-hand
wire, give its MISC1 attribute a value of "_D=4". It causes the child poles
of the multi-pole insert to move to the left to pick up the remaining two
bus wires.
NOTE The MISC1 attribute value can contain multiple special text flags which
direct Circuit Builder to handle the component or underlying wire in a special
way. When you add new values, do not overwrite any other special flag values.
Separate each one with a semicolon.
4 Save the circuit template drawing.
Control the bus wire spacing
You can set up a circuit template so the wire spacing between two or more
parallel bus wires is auto-adjusted. A marker block is positioned on each wire
and its CODE value references the (c:ace_cb_rung_spacing…) API call in the
spreadsheet. The marker blocks with a common ORDER value are processed
as a group. One of the marked wires is designated as the "base" wire, meaning
that it is the one that does not move. The other marked bus wires in the group
are then positioned set distances away from the base wire.
2052 | Chapter 24 Advanced Productivity