2011

17 Enter (c:ace_cb_insym #xyz nil “HSS112” #scl 8 nil) in the
COMMAND_LIST field.
18 Enter NO Contact in the UI_PROMPT_LIST field in the next row.
19 Enter ‘3 in the UI_VAL field in the same row.
20 Enter ‘3 in the UI_SEL field in the same row.
21 Enter (c:ace_cb_insym #xyz nil “HCR21” #scl 8 nil) in the
COMMAND_LIST field.
22 Enter None in the UI_PROMPT_LIST field in the next row.
23 Enter ‘0 in the UI_VAL field in the same row.
24 Enter ‘0 in the UI_SEL field in the same row.
Leave the COMMAND_LIST field blank, meaning that if this option is
selected no action is needed.
25 Save the spreadsheet.
NOTE A new circuit codes sheet is not always needed. Depending on the circuit
and the circuit options, the information can be added to an existing sheet. In this
example, a new sheet was created to demonstrate the procedure.
Testing the circuit
Once you create the
circuit template on page 2032, modified ACE_CIRCS on
page 2038 sheet, and added the
circuit codes on page 2039 sheet, you are ready to
test your custom circuit.
1 Make sure that you save the spreadsheet changes and close the spreadsheet
file.
2 Open a new or existing drawing to insert the circuit. Make sure that the
drawing has a vertical 3-phase bus.
3 Click Schematic tab ➤ Insert Components panel ➤ Circuit Builder
drop-down ➤ Circuit Builder.
Add a new circuit | 2041