2011

Table Of Contents
7 for the various horizontal/vertical sort orders listed in the
dialog box.
Marked with "+[32]" followed by 0= real-time error checking
mode is off, 1= mode is on.
Real-time error checking
Marked with "+[33]" to indicate a string of column names
used in grid column headers in the Wire Type commands.
Grid column headers
Marked with "+[34]" to suppress the dash (-) if it is the first
character of a tag when the Combined installation/location
component tag mode is on. See the [+10} entry.
Suppress dash
Marked with "+[35]" to indicate the delimiter character
used to separate multiple panel wire annotation values for
the same wire connection.
Panel wire annotation delimiter
Marked with "+[36]" followed by 1= item assignments per
drawing, 0 or missing= item assignments project wide.
Item number mode
Marked with "+[37]" followed by 1= allow item assignment
for each part number, 0 or missing= allow item assignment
for component only.
Item assignment
Marked with "+[38]" followed by the three character suffix
which defines the Electrical Code Standard used by Circuit
Electrical code standard
Builder when searching for a specific table in ace_electric-
al_standards.mdb on page 2015.
Circuit Builder searches for a table using the following se-
quence:
1 Tables with the three character Electrical code
standard suffix.
2 Tables without a suffix.
3 Tables with an NEC suffix.
All remaining entries give the drawing names, and any
special assignments or descriptions, that are part of the
Project drawing list
project. The special assignments or description information
precede the drawing name they are assigned to. Each line
is prefixed with a code. If special "sec/sub" groupings are
defined, then a "=" prefix indicates a sec entry for the
drawing and a "==" prefix indicates a "sub" entry . If one
186 | Chapter 3 Project Management