2011

NOTE Save the circuit template drawing after all the modifications are made.
ACE_CIRCS sheet
The ACE_CIRCS sheet in the ace_circuit_builder.xls spreadsheet controls the
circuit options displayed on the Circuit Selection dialog box. In this exercise,
you add entry to this ACE_CIRCS sheet so your new circuit option shows up
in the Circuit Selection dialog box.
1 Open ace_circuit_builder.xls for edit using a spreadsheet software. See
Circuit Builder spreadsheet overview on page ? for the location of this
file.
2 Open the ACE_CIRCS sheet.
The structure of this sheet controls the tree structure used by Circuit
Builder on the Circuit Selection dialog box. You will add a new category,
“Custom Circuits”, with one custom circuit option, “My 3-ph motor”,
within that category.
3 Enter Custom Circuits in the CATEGORY field of the first blank row below
the existing entries.
It adds a new category to the highest level of the tree display.
4 Enter My 3-ph motor in the TYPE field for the same row.
It adds an option within this new category.
5 Enter ace_cb1_FVNR_H_custom.dwg in the DWG_TEMPLATE field in
this row.
It defines which circuit template drawing to use for this option. This is
the circuit template drawing created in the
Create the circuit template
on page 2032 exercise.
6 Enter 3ph_H_custom in the SHEET_NAME field in this row.
It defines the circuit codes sheet name. This is created in the
Circuit codes
sheet
on page 2039 exercise.
7 Save the spreadsheet.
NOTE Leave the ANNO_CODE field blank. See Predefine attribute values using
annotation presets
on page 2072 to learn how to define annotation.
2038 | Chapter 24 Advanced Productivity