2011

Define wires stretching to connect to bus
The first modification is to change the way the horizontal wires connect to
the vertical bus when inserted. The copied template is defined as follows:
■ Top wire skips over two wires and connects to the left-most vertical bus
wire.
■ Middle wire skips over one wire and connects to the middle vertical bus
wire.
■ Bottom wire connects to the first vertical bus wire it encounters.
The following changes to the marker blocks reverse it.
1 Zoom in on the left-hand side of the template.
You should see three marker blocks, each with a CODE value of WCON.
Each one is directly on top of and near the end of one of the wires.
2 Enter ATTEDIT and select the top WCON marker block.
You should see the following values:
■ CODE = WCON - maps back to a row in the circuit codes sheet with
a function to stretch the end of the underlying wire to try to make a
connection.
■ ORDER = 1.02 - indicates the order of processing for the marker block
relative to all the other marker blocks in the template. The order value
can be an integer number or a decimal number. The blocks are
processed low to high starting at 0. Blocks with the same ORDER value
are processed as a group.
2034 | Chapter 24 Advanced Productivity