2011

For the middle wire: In the Signal - Source Code dialog box, click Use to
enter "CBLA-01" as the code and enter "BLUE" as the description.
For the bottom wire: In the Signal - Source Code dialog box, click Use to
enter "CBLA-02" as the code and enter "WHT" as the description.
Notice that the wires change from blue to red, and the descriptions BLUE
and WHT display on both sets of wires.
13 Press Esc to exit the command.
14 Select all of the wires and verify that they are on the _MULTI_WIRE layer.
Creating connecting wires
1 At the command line, type L and press Enter.
2 Click the end of the uppermost wire and drag down across each of the
wires connected to the push buttons. Continue dragging past the push
buttons and click.
3 Drag your cursor to the right to create a horizontal line, and click.
4 Drag down across the ends of the wires connected to the limit switches,
ending on the bottom wire and click. Press Enter to create the lines.
1994 | Chapter 24 Advanced Productivity