2011

Any device can have pins assigned to it, but common components that carry
pin assignments are relays, motor starters, and connectors. Pins are used for:
■ Error checking
■ Accurate connection information
■ Providing correct connections
You can expand the Pin List database table as needed. Many users have
difficulty creating their own database entries so the following procedures
simplify this procedure for you.
Basic workflow
Pin lists are directly associated to catalog numbers and therefore are not applied
to a component symbol until the catalog number has been assigned. You can
use wildcards inside the Pin List database to find the catalog number to apply
a single pin list to multiple symbols. The basic workflow for pin numbers
being assigned to a symbol is as follows:
■ Insert a component.
■ On the Insert/Edit Component dialog box, assign a catalog number.
■ Pin List database is queried.
■ Coil pins are applied to the parent symbol's terminal attributes.
■ The Pin List is applied to the parent symbol as xdata or attributes.
If the pin numbers are assigned as xdata, there is not a PINLIST attribute
since the pin assignment comes from the pin list table.
Setting up COILPINS
The COILPINS column in the Pin List database specifies the terminal pin
numbers for a coil or parent symbol of a component. This is generally two
pin numbers separated by a comma (such as K1,K2). When a component calls
for additional pin assignments on the parent, you can continue the list with
each value separated by commas. These values are applied to the TERM01 and
TERM02 attributes respectively on the parent symbol.
If you set COILPINS = "K1,K2;" then pins K1/K2 are assigned to the parent
symbol of a component.
In the example below, TERM01 = K1 and TERM02 = K2.
1982 | Chapter 24 Advanced Productivity