2011

Convert device pins to wire connection attributes
1 Click Conversion Tools tab ➤ Tools panel ➤ Add Wire Connections.
2 Respond to the prompts as follows:
Select block TAG or PLC Address: Select 9PB
Select end of wire (P=Pick Location): Enter P and press ENTER
Select location (W=Wire):
Press SHIFT + right-click to select Endpoint from the Snap options, select the
end point of the first wire on line 401
In the Wire Direction dialog box, select from left.
Select TERM01 text object: Select 22 (underneath 9PB TAG)
NOTE Visual indicators (x) appear where the wire connection attributes have
been applied.
Select location (W=Wire):
Press SHIFT + right-click to select Endpoint from the Snap options, select the
end point of the second wire on line 401
In the Wire Direction dialog box, select from right.
Select TERM02 text object: Select 55 (underneath line 401), right-click
You are back at the prompt to Select block TAG or PLC Address.
3 Repeat for 10PB - 12PB.
NOTE You may have to right-click several times to exit the command.
Adding Wire Connections | 1939