2011

5 Select Connection direction: Left & Top.
It determines the direction the wire attaches to the component.
6 Enter “L” as the value for TERM01 in Pin Information.
7 Select X2TERMDESC01 in Pin Information and click Delete.
8 Click Insert.
9 Select the Insert Wire Connection tool and insert the terminal in the
upper left-hand corner as shown.
NOTE Always use AutoCAD Snap to insert the wire connection point.
10 Back on the Symbol Builder Attribute Editor, expand the Wire Connection
Direction / Style list and select Right & Top / Screw.
11 Select the Insert Wire Connection tool and insert the terminal in the
upper right-hand corner.
You can continue to insert wire connections until you press ENTER by
entering the characters indicated in the command line prompt followed
by a space. You can also select from the Direction / Style list.
12 Insert the rest of the terminals as follows:
TERM03: Right
Insertion Point: below TERM02
TERM04: Bottom
Insertion Point: in the lower right-hand corner
TERM05: Bottom
Insertion Point: to the left of TERM04
TERM06: Bottom
1928 | Chapter 23 Tutorials